When using the wireless switching remote or wall switch in the dimming only function is very easy. Both the remote and wall switch has four buttons marked 1-4. This allows you to have four independent lights (see diagrams below). A light i.e. wall light is wired to a ceiling receiver that had been paired to button 1. When you press button 1 that light comes on then you use the up & down buttons to dim.
The next item you wish to be incorporated in the system i.e. a ceiling light is then wired to another ceiling receiver that has been paired to button 2.
The next item you wish to be incorporated in the system i.e. a table lamp is then wired to a floor receiver that has been paired to button 3.
The next item you wish to be incorporated in the system i.e. a floor lamp is then wired to a floor receiver that has been paired to button 3.
NOTE: There are two types of receivers. Wall lights and ceiling lights must be used with ceiling receivers, floor lamps and table lamps must be used with floor receivers.
Each receiver is capable of switching 350w of both mains or low voltage load. You can have more wall lights paired as long as you do not exceed the loading. They can be wired to the same receiver (if possible) or have their own receiver that is set to the relevant button on the remote / wall switch.
